Table of Contents
Advertisement
limit-queue-length
Sets for a Switch the maximum send queue length of a physical port.
If this command is omitted or if setting information is deleted, the send queue length is set to
32.
This command is used to set basic operating conditions for the hardware. You must restart
the Switch after you change the settings.
Input format
To set or change information:
limit-queue-length
To delete information:
no limit-queue-length
Input mode
(config)
Parameters
<Queue length>
Sets the maximum queue length of a physical port.
1.
2.
Default behavior
32 is used as the send queue length for a port on a Switch.
Impact on communication
The Switch must be restarted. Communication via the Switch stops until the restart
processing has been completed.
When the change is applied
If you have changed any values, save the configuration and restart the Switch. The new
setting values take effect when the Switch is restarted.
Notes
1.
When this command is entered, the message below is displayed. Before entering
another configuration command, save the settings and restart the Switch.
Please execute the reload command after save,
because this command becomes effective after reboot.
2.
Before setting this command, use the
mode PQ. The PQ scheduling mode cannot be set from other scheduling modes.
<Queue length>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
32, 128, or 728 is set.
command to set scheduling
qos-queue-list
limit-queue-length
331
Advertisement
Table of Contents
