Ip Verify Source - Alaxala AX1250S Software Manual

ip verify source

Set this command to use the terminal filter based on the DHCP snooping binding database.
(The terminal filter is functionality used to filter the packets of unregistered source IP and
MAC addresses.)
Input format
To set or change information:
ip verify source [ { port-security | mac-only } ]
To delete information:
no ip verify source
Input mode
(config-if)
Parameters
{ port-security | mac-only }
Sets a terminal filter condition.
port-security
mac-only
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. The terminal filter functionality is disabled on trusted ports even if this command is
set.
2. If this command is set when DHCP snooping is enabled, the terminal filter
functionality is enabled even in a VLAN for which DHCP snooping is not valid.
Applies the terminal filter to both the source IP and the source MAC addresses.
Applies the terminal filter only to source MAC addresses.
Default value when this parameter is omitted:
The terminal filter is applied only to source IP addresses.
Range of values:
None
ip verify source
247