Authentication Force-Authorized Enable - Alaxala AX1250S Software Manual

authentication force-authorized enable

authentication force-authorized enable
When the following state exists for all Layer 2 authentications, a terminal subject to
authentication that requested authentication is forcibly changed to the authenticated state.

The set RADIUS server does not respond when RADIUS authentication is specified.
Input format
To set information:
authentication force-authorized enable
To delete information:
no authentication force-authorized enable
Input mode
(config)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. Be especially careful when using this functionality, as it can pose security problems.
2 In dynamic VLAN mode, assign the native VLAN of the applicable port as the
post-authentication VLAN.
If you want to assign a specific VLAN as the post-authentication VLAN, do so by
using the
3. If at least one of the following commands is set for a Switch, the
force-authorized enable






4. Setting this command enables private traps. In addition to Web authentication and
MAC-based authentication traps, IEEE 802.1X private traps are also issued.
362
authentication force-authorized vlan
dot1x force-authorized
dot1x force-authorized vlan
mac-authentication force-authorized vlan
mac-authentication static-vlan force-authorized
web-authentication force-authorized vlan
web-authentication static-vlan force-authorized
command cannot be set:
command.
authentication