Dot1X Vlan Dynamic Ignore-Eapol-Start - Alaxala AX1250S Software Manual

dot1x vlan dynamic ignore-eapol-start

dot1x vlan dynamic ignore-eapol-start

Set this command so that the Switch does not issue EAP-Request/Identity packets in
response to EAPOL-Start from a supplicant.
Input format
To set information:
dot1x vlan dynamic ignore-eapol-start
To delete information:
no dot1x vlan dynamic ignore-eapol-start
Input mode
(config)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
been set.
4. This command can be set only on an interface on which the
reauthentication
dynamic supplicant-detection
5. The
interface on which
supplicant-detection
6. If the
cannot use the
re-authentication.
412
command set and
dot1x vlan dynamic ignore-eapol-start
disable
command.
dot1x vlan dynamic ignore-eapol-start
no dot1x vlan dynamic reauthentication
dot1x system-auth-control
dot1x vlan dynamic enable
is not set for the
disable
command.
is set for the dot1x vlan dynamic
command has
dot1x vlan dynamic
dot1x vlan
command cannot be set on an
command has been set, you
command to set no