Table of Contents
Advertisement
2.
mac-based
Set this parameter for MAC VLANs.
1.
2.
Default behavior
No VLANs are configured.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
There is always a default VLAN (
VLAN are different from those of other normal VLANs.
2.
If you set a list by using
Note, however, that under some conditions (multi-command mode) lists cannot be
set for some commands. For details, see the following table.
Command
Item
No.
state {suspend | active}
1
name
2
protocol
3
mac-address
4
Legend Y: Yes; N: No
3.
The default VLAN setting (
Notes on using this parameter:
- When configuring protocol VLANs, you must set
- You cannot specify this parameter for VLANs you have already created as
port VLANs and MAC VLANs.
Default value when this parameter is omitted:
The VLANs become port VLANs.
Notes on using this parameter:
- When configuring MAC VLANs, you must set
- You cannot specify this parameter for VLANs you have already created as
port VLANs and protocol VLANs.
<VLAN ID
VLAN ID=1
mac-based
VLAN ID = 1
). The configuration items for the default
list>, you can configure multiple VLANs at one time.
Usable in multi-command mode
Y
N
Y
N
) always exists in the configuration file and
protocol-based
.
.
vlan
141
Advertisement
Table of Contents
