Table of Contents
Advertisement
flowcontrol
1.
2.
Default behavior
10BASE-T, 100BASE-TX, or 100BASE-FX port: Both receive operation and send operation
are
off
.
1000BASE-T or 1000BASE-X port: Receive operation is
Impact on communication
If this command is set for the port in use, the port goes down and communication stops
temporarily. Thereafter, the port restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If either
2.
If
desired
negotiation. For any setting other than auto-negotiation,
3.
For 100BASE-FX, no specific operation is performed when auto-negotiation is set
because auto-negotiation is not supported.
Related commands
None
80
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
receive desired
,
receive on
flowcontrol send
or
is set and auto-negotiation is set, operation is determined based on
,
receive off
off
receive
is set to
on
, both are set to
but send operation is
desired
on
.
is fixed to
flowcontrol
.
.
on
Advertisement
Table of Contents
