Spanning-Tree Pathcost Method - Alaxala AX1250S Software Manual

spanning-tree pathcost method

spanning-tree pathcost method
Sets whether to use a 16-bit value or a 32-bit value as the path cost of a port. This command
is applied to PVST+ and single spanning trees, but not to multiple spanning trees.
When the
single pathcost method
method command is not applied.
If setting of the
single cost
to the interface speed and the

When
For 10 Mbit/s: 100
For 100 Mbit/s: 19
For 1 Gbit/s: 4

When
For 10 Mbit/s: 2000000
For 100 Mbit/s: 200000
For 1 Gbit/s: 20000
Input format
To set or change information:
spanning-tree pathcost method { long | short }
To delete information:
no spanning-tree pathcost method
Input mode
(config)
Parameters
{ long | short }
If long
1.
2.
3.
176
spanning-tree vlan pathcost method
command is set, the value of the
spanning-tree cost
command is omitted, the following value is applied to the path cost according
spanning-tree pathcost method
short is set for the
long is set for the spanning-tree pathcost method
is set, a 32-bit value is used. If
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
long or short
Notes on using this parameter:
- The default value of the path cost changes.
- Changing the path cost value might change the topology.
- When 65536 or a larger value is set for the path cost, you cannot change the
parameter to .
short
command or the
, spanning-tree vlan cost
spanning-tree pathcost method
short is set, a 16-bit value is used.
spanning-tree
spanning-tree pathcost
, or spanning-tree
command settings.
command:
command: