Table of Contents
Advertisement
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed. Note, however, that for
protocols that have not been set by the
change is applied when the protocol name is set by the
Notes
1.
If a value smaller than 05ff is set for the
0000 is set.
2.
For
<HEX
When you specify multiple values, use a comma (
3.
ethertype
llc
, and
snap-ethertype
operation command.
4.
A maximum of 16
5.
The same protocol value cannot be specified multiple times on one line. (Example:
vlan-protocol xxx ethertype
6.
Protocol names set by the
Related commands
protocol
enum>, one or more
ethertype
,
llc
, and
snap-ethertype
are displayed in this order for the
values can be specified on a single line.
ethertype
protocol
protocol
command for the protocol VLAN, the
protocol
ethertype
value (four-digit hexadecimal),
values (four-digit hexadecimal) can be set.
) as the delimiter.
,
can be entered in any order, but
<HEX>
llc
<HEX>
ethertype
command cannot be deleted.
vlan-protocol
command.
ethertype
show running-config
<HEX>).
145
,
Advertisement
Table of Contents
