Dot1X Max-Req - Alaxala AX1250S Software Manual

dot1x max-req

dot1x max-req
Sets the maximum number of EAP-Request retransmissions if the value exceeds the
supp-timeout value. If the number of retransmissions exceeds this value, authentication is
determined to have failed.
Input format
To set or change information:
dot1x max-req
To delete information:
no dot1x max-req
Input mode
(config-if)
Parameters
<Counts>
Sets the maximum number of EAP-Request retransmissions.
1.
2.
Default behavior
The maximum number of EAP-Request retransmissions is two.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. The
port-control
Related commands
dot1x system-auth-control
dot1x timeout supp-timeout
dot1x port-control
386
<Counts>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 10 (times)
dot1x timeout tx-period
command has been set.
dot1x system-auth-control
command takes effect only if the dot1x