Table of Contents
Advertisement
dot1x vlan dynamic reauthentication
After a successful IEEE 802.1X authentication, this command sets whether a supplicant is
to be re-authenticated. When this command is in effect, EAP-Request/Identity packets for
re-authentication are sent to a supplicant at the interval set by using the
dynamic timeout reauth-period
Input format
To set information:
dot1x vlan dynamic reauthentication
To delete information:
no dot1x vlan dynamic reauthentication
Input mode
(config)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3.
This command takes effect only if the
been set.
4.
If the
cannot use the
re-authentication.
Related commands
dot1x system-auth-control
dot1x vlan dynamic ignore-eapol-start
dot1x vlan dynamic timeout reauth-period
dot1x vlan dynamic enable
dot1x vlan dynamic ignore-eapol-start
no dot1x vlan dynamic reauthentication
command as a prompt for supplicant re-authentication.
dot1x system-auth-control
dot1x vlan dynamic enable
dot1x vlan dynamic reauthentication
dot1x vlan
command has
command has been set, you
command to set no
417
Advertisement
Table of Contents
