Table of Contents
Advertisement
end
Ends configuration command mode and returns you to administrator mode.
Input format
end
Parameters
None
Response messages
The following table describes the response messages for the
Table 3-1 Response messages for the end command
Message
Unsaved changes would be lost when the
machine goes to sleep!
Do you exit "configure" without save ?
(y/n):
The machine is just going to sleep! Do you
exit ? (y/n):
Notes
1.
You can use the
without saving the configuration file to internal flash memory. Because the
configuration file at this time is still being edited, first edit the configuration file, and
then save it.
2.
After editing the running configuration, if you execute the
saving the changes you made to internal flash memory, the startup configuration file
in internal flash memory and the running configuration will no longer be the same.
After editing the configuration, you must always save your changes.
Related commands
None
Description
When the following commands are configured,
configuration command mode will end without any
changes being saved:
schedule-power-control system-sleep
schedule-power-control time-range
The configuration changes you made will be lost when
the Switch switches to sleep mode. Enter
editing. Enter
necessary, use the
configuration.
If configuration command mode ends, the Switch will
switch to sleep mode.
Enter
to switch to the sleep state, enter
command, and then use the
power-control schedule disable
set the power saving schedule functionality to
suppression mode.
command to temporarily exit configuration command mode
end
command.
end
n
end
to cancel the
save
command to save the edited
y
to switch to the sleep state. If you do not want
(config)# $set
end
command without
end
y
to finish
command. If
n
end
to cancel the
command to
15
Advertisement
Table of Contents
