36.1.23 Multistep Authentication Information; 36.1.24 Uplink Redundancy Information - Alaxala AX1250S Software Manual

Index

36.1.23 Multistep authentication information

Table 36-24 Multistep authentication error messages
Message
interface : Relations between
authentication configuration
and channel-group configuration
within same port.
interface : Relations between
multi-step configuration and
legacy mode configuration(s)
are inconsistent.

36.1.24 Uplink redundancy information

Table 36-25 Uplink redundancy error messages
Message
Can't set ethernet
it is a channel-group port.
Ethernet is already an
<IF#>
uplink redundant interface.
Ethernet Relations ring
<IF#>
protocol and between uplink
redundant are inconsistent.
Port-channel
<Channel group#>
already an uplink redundant
interface.
Port-channel
<Channel group#>
Relations ring protocol and
between uplink redundant are
inconsistent.
Secondary interface is same as
primary interface.
686
Explanation
An authentication common command and a channel group
command cannot be set at the same time. Delete the settings of the
channel-group mode
authentication multi-step
The
because legacy mode is enabled.
Delete the following:
dot1x vlan dynamic enable
dot1x vlan dynamic radius-vlan
mac-authentication interface
mac-authentication vlan
web-authentication vlan
Explanation
because
<IF#> The interface configuration cannot be changed because the
specified interface belongs to a channel group.
<IF#>: Interface port number
The uplink redundant functionality has already been set for the
specified interface.
<IF#>: Interface port number
The Ring Protocol functionality has already been set for the specified
interface. Either delete the Ring Protocol functionality or specify
another interface.
<IF#>: Interface port number
is
The uplink redundant functionality has already been set for the
specified interface.
<Channel
The Ring Protocol functionality has already been set for the specified
interface. Either delete the Ring Protocol functionality or specify
another interface.
<Channel
The primary interface and the secondary interface are configured on
the same port.
command.
group#>: Port channel number
group#>: Port channel number
command cannot be set