36.1.20 Ieee 802.1X Information - Alaxala AX1250S Software Manual

36.1.20 IEEE 802.1X information

Table 36-20 IEEE 802.1X error messages
Message
dot1x(xxxxx): Cannot set "dot1x
port-control" because monitor
session mode is set now.
dot1x(xxxxx): Cannot set " dot1x
authentication " command
because user-group or legacy
mode configuration(s) is set
now.
dot1x(link-aggregation):
Cannot set the configuration
because the ethernet <IF#>
belongs to the port-channel
dot1x(link-aggregation): The
specified ethernet
add to the specified
port-channel(<Channel
because 802.1X configuration is
different.
dot1x(vlan dynamic): Cannot set
"dot1x vlan dynamic
ignore-eapol-start" because
supplicant-detection is
disable-method.
dot1x(vlan dynamic): Cannot set
"dot1x vlan dynamic
ignore-eapol-start" because
reauthentication mode is
invalid.
dot1x(vlan dynamic): Cannot set
"dot1x vlan dynamic
radius-vlan" because the
specified vlan
<VLAN ID>
found.
dot1x(vlan dynamic): Cannot set
"dot1x vlan dynamic
radius-vlan" because the
specified vlan
<VLAN ID>
mac-vlan.
Explanation
Port-based authentication cannot be set because port mirroring of
the xxxxx
xxxxx:
ethernet
dot1x authentication
The
the authentication method for each user ID or legacy mode is
enabled on the
Delete the following:
dot1x vlan dynamic enable
dot1x vlan dynamic radius-vlan
web-authentication user-group
web-authentication vlan
mac-authentication interface
mac-authentication vlan
IEEE 802.1X cannot be set because the specified
belongs to the port channel.
<IF#>: Interface port number
ethernet
cannot
<IF#>
<Channel group#>
802.1X configuration, which must be consistent within the link
group#>)
aggregation, is different.
<IF#>: Interface port number
<Channel
The functionality for suppressing the re-authentication of requests
from a terminal cannot be set because
detection mode for VLAN-based authentication (dynamic).
The functionality for suppressing the re-authentication of requests
from a terminal cannot be set because the re-authentication request
functionality of VLAN-based authentication (dynamic) is not
enabled.
The specified
VLAN because the
<VLAN
is not
The specified
VLAN because
<VLAN
is not
interface is enabled.
<IF#>: Ethernet interface port number
command cannot be set because
xxxxx interface.
<IF#> cannot be registered in
that has been specified because the IEEE
group#>: Channel group number
VLAN
<VLAN ID> cannot be registered as the radius
VLAN
<VLAN ID>
ID>: VLAN ID
VLAN
<VLAN ID> cannot be registered as a radius
VLAN
<VLAN ID>
ID>: VLAN ID
ethernet
port-channel
disable
is set as terminal
is not registered on the Switch.
is not a MAC VLAN.
Index
<IF#>
677