Table of Contents
Advertisement
ip qos-flow-list
ip qos-flow-list
Creates an IPv4 QoS flow list to be used to set QoS flow detection and operation settings. A
maximum of 1024 IPv4 and MAC QoS flow lists can be created for a Switch. A maximum of
1024 entries can be created for flow detection and operation settings.
Input format
To set or change information:
ip qos-flow-list
To delete information:
no ip qos-flow-list
Input mode
(config)
Parameters
<QoS flow list name>
Sets the IPv4 QoS flow list name.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
The names of existing QoS flow list cannot be set.
Related commands
ip qos-flow-group
ip qos-flow-list resequence
qos (ip qos-flow-list)
remark
328
<QoS flow list name>
<QoS flow list name>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Set 3 to 31 characters, the first character of which must be a non-numeric
character. For details about the characters that can be specified, see
Specifiable values for parameters.
Advertisement
Table of Contents
