Table of Contents
Advertisement
ntp client server
Sets the address of the NTP server from which time information can be obtained. A
maximum of two entries can be set.
Input format
To set or change information:
ntp client server
To delete information:
no ntp client server
Input mode
(config)
Parameters
<Server IP>
Sets the IP address of the NTP server from which the time information can be
obtained.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If
ntp client server
both set, the
2.
127.*.*.*
Related commands
ntp client broadcast
ntp client multicast
ntp interval
<Server IP>
<Server IP>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1.0.0.0 to 126.255.255.255, 128.0.0.0 to 223.255.255.255
and
ntp client broadcast
ntp client server
cannot be specified as an IPv4 address.
or
ntp client multicast
setting is effective.
ntp client server
are
43
Advertisement
Table of Contents
