Table of Contents
Advertisement
loop-detection interval-time
loop-detection interval-time
Sets the interval for sending L2 loop detection frames.
Input format
To set or change information:
loop-detection interval-time
To delete information:
no loop-detection interval-time
Input mode
(config)
Parameters
<Seconds>
Sets the interval (in seconds) for sending L2 loop detection frames.
1.
2.
Default behavior
The interval for sending L2 loop detection frames is 10 seconds.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
loop-detection enable
590
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 3600 (seconds)
<Seconds>
Advertisement
Table of Contents
