Web-Authentication Web-Port - Alaxala AX1250S Software Manual

web-authentication web-port

web-authentication web-port
When the URL redirect functionality is enabled, this command sets an additional TCP
destination port number for a frame subject to URL redirect on a Switch.
Usually, one port number each can be added to the port number assigned for http (80) and
for https (443).
Input format
To set or change information:
web-authentication web-port
To delete information:
no web-authentication web-port {http | https}
Input mode
(config)
Parameters
{http <port>
Specify the port number to be used for http protocol or https protocol communication.
Note that if OAN is also used, port numbers 832 and 9698 are used by OAN.


Default behavior
Frames with the following initial port number are subject to URL redirection.

http: 80

https: 443
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the
system-auth-control
2. See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3. The number of TCP destination port numbers that can be set by using this command
494
| https <port> }
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
For the http parameter: 1 to 65535 (except 443)
For the https parameter: 1 to 65535 (except 80)
command is set.
{http <port> | https
web-authentication
<port>}