Table of Contents
Advertisement
mac-authentication auto-logout
1.
2.
Default behavior
Fixed VLAN mode, dynamic VLAN mode
After authentication in either of these authentication modes, if no frames are received
from a terminal for the applicable MAC-based authentication entry when 3600
seconds has passed, the applicable MAC-based authentication entry is deleted from
the MAC table automatically and authentication is canceled.
Legacy mode
When 3600 seconds have passed after the MAC address table aging period has
timed out, authentication of the terminal to which the applicable MAC address is
assigned is automatically canceled.
Impact on communication
After the
no mac-authentication auto-logout
automatically canceled even if a terminal authenticated using MAC-based authentication
detects that forwarding has not been performed on the terminal for a certain period of time.
If
mac-authentication auto-logout delay-time
to the time that has been set.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All MAC-based authentication settings take effect when the
system-auth-control
2.
See Configuration commands and MAC-based authentication modes for the
authentication mode in which the command's settings are operable.
3.
The non-communication monitoring time on an authenticated terminal in fixed VLAN
mode or dynamic VLAN mode takes effect if the following condition exists:
Related commands
mac-authentication system-auth-control
mac-authentication port
mac-address-table aging-time
518
Default value when this parameter is omitted:
After an aging timeout, authentication is not canceled for 3600 seconds.
Range of values:
0, 60 to 86400
command is set.
The MAC-based authentication fixed VLAN mode or dynamic VLAN mode is in
effect and
mac-authentication auto-logout
command is set, authentication is not
is set, the terminal operates according
mac-authentication
is enabled.
Advertisement
Table of Contents
