Table of Contents
Advertisement
switchport access
switchport access
Sets the access port information.
Input format
To set or change information:
switchport access vlan
To delete information:
no switchport access vlan
Input mode
(config-if)
Parameters
<VLAN ID>
vlan
Sets a VLAN for an access port. Specifiable VLANs are port VLANs or MAC VLANs.
A protocol VLAN cannot be set.
1.
2.
Default behavior
The access port of the default VLAN (VLAN ID = 1) is used.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If an untagged frame or tagged frame of a port VLAN is received, the frame is handled
by the port VLAN. If a tagged frame of a VLAN other than a port VLAN is received, the
frame is discarded.
Related commands
switchport mode
vlan
128
<VLAN ID>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
See Specifiable values for parameters.
Advertisement
Table of Contents
