Table of Contents
Advertisement
web-authentication jump-url
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All Web authentication settings take effect when the
system-auth-control
2.
See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3.
When the Authentication Success page is replaced by using the
web-authentication html-files
(
<!-- Redirect_URL -->
of this command in the Authentication Success page file (
replaced. By doing this, the page specified by the URL appears automatically after
successful authentication.
4.
When fixed VLAN mode is used, setting the time required before jumping to the
specified URL is not necessary. Specify the value if you want to automatically display
the URL faster than the default setting.
5.
When dynamic VLAN mode or legacy mode is used, the IP address of the
authentication terminal must be changed for switching from an pre-authentication
VLAN to an authenticated VLAN. Therefore, set the time required before jumping to
the specified URL to approximately 20 to 30 seconds.
Related commands
web-authentication system-auth-control
web-authentication port
web-authentication vlan
448
command is set.
) to jump to after successful authentication and the settings
If IP addresses have been distributed to unauthenticated terminals on the
internal DHCP server (default lease time: 10 seconds), the IP addresses are
obtained from the normal DHCP server for an authenticated VLAN.
Accordingly, it might take approximately 20-30 seconds before an
authenticated VLAN can communicate after the completion of authentication.
web-authentication
operation command, write the tag of the URL
loginOK.html
set
) that is to be
Advertisement
Table of Contents
