Table of Contents
Advertisement
dot1x reauthentication
dot1x reauthentication
After a successful IEEE 802.1X authentication, this command sets whether a supplicant is
to be re-authenticated. When this command is in effect,
for re-authentication are sent at the interval set by using the
reauth-period
Input format
To set information:
dot1x reauthentication
To delete information:
no dot1x reauthentication
Input mode
(config-if)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3.
The
port-control
4.
If the
dot1x reauthentication
Related commands
dot1x ignore-eapol-start
dot1x timeout reauth-period
dot1x system-auth-control
dot1x port-control
396
command to a supplicant as a prompt for supplicant re-authentication.
dot1x timeout tx-period
command has been set.
dot1x ignore-eapol-start
EAP-Request/Identity
dot1x system-auth-control
command takes effect only if the
command has been set, you cannot use the
command to set no re-authentication.
packets
dot1x timeout
dot1x
no
Advertisement
Table of Contents
