Mac-Authentication Interface - Alaxala AX1250S Software Manual

mac-authentication interface

mac-authentication interface
Sets the applicable interface ports in MAC-based authentication legacy mode.
Input format
To set or change information:
mac-authentication interface fastethernet
mac-authentication interface gigabitethernet
To delete information:
no mac-authentication interface fastethernet
no mac-authentication interface gigabitethernet
Input mode
(config)
Parameters
<IF# list>
Sets ports for MAC-based authentication.
1.
2.
Default behavior
MAC-based authentication legacy mode is not used.
Impact on communication
If an interface is deleted by using this command, the legacy mode authentication terminal
registered on the interface you have deleted is released.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All MAC-based authentication settings take effect when the
system-auth-control
2. See Configuration commands and MAC-based authentication modes for the
authentication mode in which the command's settings are operable.
3. If at least one of the following commands is set for a Switch, this command cannot be
set:


524
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
See Specifiable values for parameters.
command is set.
authentication multi-step
dot1x authentication
<IF# list>
<IF# list>
mac-authentication