Table of Contents
Advertisement
flow detection mode
flow detection mode
Sets the flow detection mode for the filtering and QoS functionality.
This command changes the distribution pattern for the maximum number of entries in a
hardware table.
By changing the distribution pattern according to the operating mode, you can collect
hardware resources in the necessary tables and use them.
This command is used to set the basic operating conditions for hardware. If you want to
change the distribution pattern, you must delete the
ip qos-flow-group
Accordingly, you must set this command during the first step of actual operation. We
recommend that you do not change the distribution pattern during operation.
If you do not set this command or if the information has been deleted,
its default state.
Input format
To set or change information:
flow detection mode {layer2-1 | layer2-2}
To delete information:
no flow detection mode
Input mode
(config)
Parameters
{layer2-1 | layer2-2}
Sets the flow detection mode.
1.
2.
The following table describes the commands applicable to the flow detection modes.
Table 18-1 Commands applicable to flow detection mode
Flow detection mode
Layer 2-1
Layer 2-2
270
, and
mac qos-flow-group
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
None
ip access-group
commands if they have been set.
Applicable command
mac
access-group
qos-flow-group
Y
N
,
mac access-group
returns to
layer2-2
ip
access-group
qos-flow-group
N
Y
,
Advertisement
Table of Contents
