Spanning-Tree Link-Type - Alaxala AX1250S Software Manual

spanning-tree link-type

Sets the link type of the applicable port. This command is applied to the applicable PVST+,
single-spanning-tree, and multiple-spanning-tree ports. If you change the high-speed
topology when
rapid-pvst
bridges must be a point-to-point connection. If you want to change the high-speed topology,
the connection between bridges must be a point-to-point connection when
for the spanning-tree single mode
Input format
To set or change information:
spanning-tree link-type { point-to-point | shared }
To delete information:
no spanning-tree link-type
Input mode
(config-if)
Parameters
{ point-to-point | shared }
If point-to-point
is set, shared connection is used for the link type.
1.
2.
Default behavior
point-to-point
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If point-to-point
mode operates. If
compatibility mode does not operate.
rapid-pvst or mst is set for the
is set for the spanning-tree vlan mode
is set, point-to-point connection is used for the link type. If
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
or
point-to-point shared
is used for a full-duplex port and
is set, the automatic restoration functionality for STP compatibility
is set, the automatic restoration functionality for STP
shared
spanning-tree mode
command, the connection between
command.
shared is used for a half-duplex port.
spanning-tree link-type
command, and
rapid-stp is set
shared
159