Alaxala AX1250S Software Manual page 562

mac-authentication radius-server host
retransmit
Sets the number of times an authentication request is resent to the RADIUS server.
1.
2.
key <String>
Sets the RADIUS key used for encryption or for authentication of communication with
the RADIUS server. The same RADIUS key must be set for the client and the
RADIUS server.
1.
2.
Default behavior
The RADIUS server settings registered by using the
used.
If the radius-server host
using the internal Web authentication database without using the RADIUS server.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All MAC-based authentication settings take effect when the
system-auth-control
2. See Configuration commands and MAC-based authentication modes for the
authentication mode in which the command's settings are operable.
3. When this command is set, the setting information of the RADIUS server referenced
by MAC-based authentication has precedence over the information set by using the
radius-server host
are not applied). For details about settings for the general RADIUS server information
and the MAC-based authentication RADIUS server information, see the
Configuration Guide Vol. 2.
4. A maximum of 4 MAC-based authentication RADIUS servers can be specified for
each Switch.
5.
127.*.*.*
538
1 to 30 (seconds)
<Retries>
Default value when this parameter is omitted:
The number of times set by using the
is used. If no value is set, the initial value is 3.
Range of values:
0 to 15 (times)
Default value when this parameter is omitted:
The RADIUS key set by using the
key is set, the RADIUS server is disabled.
Range of values:
Specify a character string that is no more than 64 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
command is not registered, user authentication is performed by
command is set.
command (the settings of the
cannot be specified as an IPv4 address.
radius-server retransmit
radius-server key command is used. If no
radius-server host
mac-authentication
radius-server host
command
command are
command