Mac-Address-Table Aging-Time - Alaxala AX1250S Software Manual

mac-address-table aging-time

Sets the aging conditions for MAC address table entries.
Input format
To set or change information:
mac-address-table aging-time
To delete information:
no mac-address-table aging-time
Input mode
(config)
Parameters
<Seconds>
Sets the aging time in seconds. If
1.
2.
Default behavior
300 seconds is set as the aging time.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. A Switch checks for received frames each time the specified aging time elapses.
Accordingly, at a maximum, twice the aging time might be required for the learned
entries to be deleted.
2. When any of the following settings is in effect, an aging time of 10 to 300 seconds set
by this command is set to 300 seconds.

When IEEE 802.1X port-based authentication (static) or port-based authentication
(dynamic) is in effect, and

When Web authentication fixed VLAN mode or dynamic VLAN mode is in effect, and
web-authentication auto-logout

When the MAC-based authentication fixed VLAN mode or dynamic VLAN mode is in
effect, and
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0, 10 to 1000000 (seconds)
dot1x auto-logout
mac-authentication auto-logout
<Seconds>
0 is set, aging is not performed.
is valid.
is valid.
is valid.
mac-address-table aging-time
115