Table of Contents
Advertisement
loop-detection hold-time
Sets the time for holding the number of L2 loop detections before a port is blocked.
If the period of time for holding the number of L2 loop detections elapses without an L2 loop
detection frame being received since the last L2 loop detection frame was received, the
number of L2 loop detections held on the port is cleared.
Input format
To set or change information:
loop-detection hold-time
To delete information:
no loop-detection hold-time
Input mode
(config)
Parameters
<Seconds>
Sets the period of time in seconds for holing the number of L2 loop detections.
1.
2.
Default behavior
The number of L2 loop detections continue to be held.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
When this command has been set and the parameter is changed, if any time remains
for holding the number of L2 loop detections, the change becomes operational only
after the remaining time has been cleared.
Related commands
loop-detection enable
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 86400 (seconds)
<Seconds>
loop-detection hold-time
589
Advertisement
Table of Contents
