Spanning-Tree Loopguard Default - Alaxala AX1250S Software Manual

spanning-tree loopguard default

Sets the loop guard functionality that is used by default. This command is valid for PVST+
and single-spanning-tree ports.
Input format
To set information:
spanning-tree loopguard default
To delete information:
no spanning-tree loopguard default
Input mode
(config)
Parameters
None
Default behavior
If the
spanning-tree guard
If the spanning-tree guard
default command does not operate.
Impact on communication
None
When the change is applied

When the
portfast

If the
command settings have been deleted, loop guard operation starts immediately.
Notes
1. When the
portfast
Related commands
spanning-tree guard
command has been set, that setting is used.
command has not been set, the
spanning-tree portfast default
command is set, the loop guard setting is not applied.
spanning-tree portfast default
spanning-tree portfast default
command is set, the loop guard setting is not applied.
spanning-tree loopguard default
spanning tree loopguard
command or the
command and spanning-tree portfast
command or the
spanning-tree
spanning-tree
161