Web-Authentication Roaming - Alaxala AX1250S Software Manual

web-authentication roaming

web-authentication roaming
Sets communication permissions (roaming) when the port for an authenticated terminal
changes to another port connected via a hub or similar means without a link-down event
occurring.
Input format
To set or change information:
web-authentication roaming [action trap]
To delete information:
no web-authentication roaming
Input mode
(config)
Parameters
[action trap]
When a change to another port due to roaming is detected, a private trap is issued.


Default behavior
Changing the port of an authenticated terminal is not permitted.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the
system-auth-control
2. See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3. If the destination port is a port in dynamic VLAN mode and the change of port is within
the same VLAN, communication is possible after the change.
4. If the DHCP snooping functionality is also used when this command is set and if the
port of an authenticated terminal changes to another port, the authentication status
also moves to the destination port. However, communication is impossible because
the binding database is not updated.
478
Default value when this parameter is omitted:
When a change to another port due to roaming is detected, a private trap is not
issued.
Range of values:
action trap
command is set.
web-authentication