Table of Contents
Advertisement
mac-authentication vlan-check
Checks the VLAN ID when checking a MAC address during authentication processing.
For the RADIUS authentication method, the MAC address string and the string set by using
this command (
user ID for sending an authentication request to the RADIUS server.
For the local authentication method, the MAC address string and the VLAN ID are checked
against the internal MAC-based authentication database. (If there is no VLAN ID
information in the internal MAC-based authentication database, only the MAC address
string is used for the check.)
Input format
To set or change information:
mac-authentication vlan-check [ key
To delete information:
no mac-authentication vlan-check
Input mode
(config)
Parameters
key
<String>
This parameter applies only to the RADIUS authentication method.
The parameter sets a character string that is added to the user ID when an
authentication request is sent to the RADIUS server.
This parameter is invalid for the local authentication method.
1.
2.
Default behavior
No VLAN IDs are added during the MAC-based authentication check.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All MAC-based authentication settings take effect when the
system-auth-control
%VLAN
is set by default), and the VLAN ID are combined and used as the
Default value when this parameter is omitted:
%VLAN
is set.
Range of values:
1 to 64 characters can be set. For details about the characters that can be
specified, see Specifiable values for parameters.
command is set.
mac-authentication vlan-check
<String>
]
mac-authentication
557
Advertisement
Table of Contents
