Web-Authentication Redirect Tcp-Port - Alaxala AX1250S Software Manual

web-authentication redirect tcp-port

web-authentication redirect tcp-port
When the URL redirect functionality is enabled, this command sets an additional TCP
destination port number for a frame subject to URL redirect on a Switch.
Usually, a port number can be added to the standard port number assigned for http (80).
Input format
To set or change information:
web-authentication redirect tcp-port
To delete information:
no web-authentication redirect tcp-port
Input mode
(config)
Parameters
<Port>
Sets an additional TCP destination port number for a frame subject to URL redirection
on a Switch when the URL redirect functionality is enabled. TCP destination port
number 80 and the port number that has been set are subject to http protocol URL
redirection.


Default behavior
Frames with the following initial port number are subject to URL redirection.

http: 80

https: 443
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the
system-auth-control
2. See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3. Only one TCP destination port number can be set by using this command.
476
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535
command is set.
<Port>
web-authentication