Alaxala AX1250S Software Manual page 314

deny (mac access-list extended)
vlan <VLAN ID>
Sets the VLAN ID.
This parameter is effective only when it is applied to an Ethernet interface.
1.
2.
user-priority
Sets the user priority.
1.
2.
Default behavior
None
Impact on communication
If any entry is added when an access list with no entries set is being applied to an interface,
all packets received on the applicable interface are discarded temporarily until the entry is
applied to the interface.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If nnnn.nnnn.nnnn ffff.ffff.ffff
destination address,
2. If a protocol name is set for the destination address or if the address of a protocol
name that can be set is set, the protocol name is displayed. For details about the
address of a protocol name that can be set as the destination address, see Table
19-8 Destination MAC address names that can be specified. If
0000.0000.0000
the destination address,
3. Because the parameters set by using this command are valid only for relay packets,
they are not valid for incoming and outgoing packets. Therefore, the set parameters
are not valid for incoming and outgoing packets.
Related commands
mac access-group
mac access-list resequence
permit (mac access-list extended)
remark
290
Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
Range of values:
See Specifiable values for parameters.
<Priority>
Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
Range of values:
Set 0 to 7 (in decimal).
any is displayed.
is entered as the source address in cases other than the above and
host nnnn.nnnn.nnnn
is entered as the source address and the
is displayed.
nnnn.nnnn.nnnn