Table of Contents
Advertisement
Line type
10BASE-T/
100BASE-TX/
1000BASE-T
100BASE-FX [AX1250S]
1000BASE-X
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2.
Range of values:
100
Default behavior
auto
is set.
Impact on communication
If this command is set for the port in use, the port goes down and communication stops
temporarily. Thereafter, the port restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If
auto
or a parameter containing
performed.
2.
If auto-negotiation is not used for 10BASE-T, 100BASE-TX, or 1000BASE-T, set
speed
to
10
3.
For 1000BASE-X, if auto-negotiation will not be used, you must set
and
full
4.
If
media-type
5.
If
media-type auto
6.
When settings are fixed, MDI-X is always selected.
7.
Because 100BASE-FX does not support auto-negotiation, set
is set, there will be no transition to the link-up state.
Parameters that can be set
10
100
auto
auto 10
auto 100
auto 1000
auto 10 100
auto 10 100 1000
100
1000
auto
auto 1000
,
100
,
1000
,
auto
,
auto {10 | 100 | 1000 | 10 100 | 10 100 1000}
or
100
, and set
full
for
duplex
.
is changed, the command settings return to the default state.
is set, this command cannot be set. Use the default value.
Behavior if omitted
auto
auto
auto
auto
is set for
speed
or
or
half
for
duplex
.
speed
duplex
, auto-negotiation is
1000
for
speed
100
for
speed
. If
auto
97
Advertisement
Table of Contents
