Table of Contents
Advertisement
web-authentication ip address
Notes
1.
All Web authentication settings take effect when the
system-auth-control
2.
See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3.
If
extended-authentication
was set, this command cannot be set. (This command can be set if the
function
4.
Because the IP address set by using this command is used exclusively for Web
authentication access on a Switch, the IP address is not sent outside the Switch.
5.
When this setting is used, an IP address must be set for the pre-authentication VLAN.
6.
To use the Web authentication IP address on a port in fixed VLAN mode or dynamic
VLAN mode, you must set
7.
After this command is set or deleted, a user who is in the process of being
authenticated must log in again.
Related commands
web-authentication system-auth-control
web-authentication port
authentication arp-relay
446
command is set.
was not set when the
command was not set.)
authentication arp-relay
web-authentication
system function
command
system
.
Advertisement
Table of Contents
