Table of Contents
Advertisement
radius-server host
acct-port
Sets the port number for RADIUS server accounting.
1.
2.
retransmit
Sets the number of times an authentication request is re-sent to the RADIUS server.
1.
2.
timeout
Sets the timeout period for responses from the RADIUS server in seconds.
1.
2.
Default behavior
Because the RADIUS server has not been configured, even if
aaa
, communication with the RADIUS server cannot be established.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
A maximum of 20 general RADIUS servers can be specified for each Switch.
2.
127.*.*.*
3.
If the key parameter is omitted and the
RADIUS server is disabled.
4.
If multiple general RADIUS servers are configured, the address displayed first by
using the
general RADIUS server. The primary general RADIUS server is used as the initial
current server (the destination for RADIUS authentication requests during operation).
If a failure occurs on the primary general RADIUS server, the current server becomes
the next valid general RADIUS server (the secondary general RADIUS server). For
details about automatic restoration of the primary general RADIUS server, see the
30
<Port>
Default value when this parameter is omitted:
Port number 1813
Range of values:
to
1
65535
<Retries>
Default value when this parameter is omitted:
The number of times configured by using
If no value is set, the initial value is 3.
Range of values:
0 to 15 (times)
<Seconds>
Default value when this parameter is omitted:
The period configured by using
is set, the initial value is 5.
Range of values:
1 to 30 (seconds)
cannot be specified as an IPv4 address.
show radius-server
radius-server retransmit
radius-server timeout
radius-server key
operation command is the address of the primary
is used.
is used. If no period
group radius
is specified for
command is not set, the
Advertisement
Table of Contents
