Web-Authentication User-Group - Alaxala AX1250S Software Manual

web-authentication user-group

Enables the user ID-based authentication method.
To handle IDs in the forms
at mark ( @
Input format
To set information:
web-authentication user-group
To delete information:
no web-authentication user-group
Input mode
(config)
Parameters
None
Default behavior
Entered user IDs are not separated by an at mark (
Impact on communication
If a change is made, all authentications are canceled.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the
system-auth-control
2. See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3. If at least one of the following commands is set for a Switch, this command cannot be
set:








[ <User ID>
) to separate the entered user IDs.
command is set.
dot1x authentication
dot1x vlan dynamic enable
dot1x vlan dynamic radius-vlan
mac-authentication authentication
mac-authentication interface
mac-authentication vlan
web-authentication authentication
web-authentication vlan
] and [ <Authentication method list name>
@ ).
web-authentication
web-authentication user-group
] , use the
489