Table of Contents
Advertisement
efmoam udld-detection-count
efmoam udld-detection-count
Sets the number of OAMPDU response timeouts that must occur to recognize a failure.
(The OAMPDU is a monitoring packet of the IEEE 802.3ah/UDLD functionality.)
Input format
To set or change information:
efmoam udld-detection-count
To delete information:
no efmoam udld-detection-count
Input mode
(config)
Parameters
<Count>
Sets the number of OAMPDU response timeouts that must occur to determine that a
line failure has occurred when timeouts occur repeatedly. When the occurrence
reaches the specified number of times, the applicable port is deactivated.
1.
2.
Default behavior
30 is used as the number of times for determining a line failure.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If a value smaller than the initial value is set, a unidirectional link failure might be
falsely detected.
Related commands
None
578
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
3 to 300 (times)
<Count>
Advertisement
Table of Contents
