Table of Contents
Advertisement
dot1x vlan dynamic supplicant-detection
dot1x vlan dynamic supplicant-detection
Sets the behavior when a new terminal is detected.
Input format
To set or change information:
dot1x vlan dynamic supplicant-detection {disable | shortcut}
To delete information:
no dot1x vlan dynamic supplicant-detection
Input mode
(config)
Parameters
{disable | shortcut}
Sets the behavior when a new terminal is detected.
disable
shortcut
1.
2.
Default behavior
shortcut
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
418
Suppresses EAP-Request/Identity transmission processing for detecting a
new terminal. Set this parameter in cases when a supplicant that operates
abnormally due to omission of the authentication sequence in order to
decrease Switch load is used.
If this parameter is set, authentication processing for a supplicant for which
authentication cannot be initiated from the terminal cannot be started.
Omits the authentication sequence of an authenticated terminal during
EAP-Request/Identity transmission processing for detecting a new terminal to
reduce the load. Set this parameter for a supplicant that is unable to initiate
authentication from a terminal.
If this parameter is set, some supplicants do not operate correctly and
communication temporarily stops.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
None
is used as the operation when a new terminal is detected.
Advertisement
Table of Contents
