Table of Contents
Advertisement
permit (mac access-list extended)
Sets the conditions for permitting access in MAC filtering.
Input format
To set or change information:
[
<Seq>
MAC> <Dst MAC mask>
| oadp | pvst-plus-bpdu } [
[user-priority
To delete information:
no
Input mode
(config-ext-macl)
Parameters
<Seq>
Sets the sequence in which filter conditions are applied.
1.
2.
{
<Src MAC> <Src MAC mask>
Sets the source MAC address.
To set all source MAC addresses, set
1.
2.
] permit {
<Src MAC> <Src MAC mask>
| host
<Priority>
<Seq>
Default value when this parameter is omitted:
10 is set as the initial value if there are no conditions in the access list.
If conditions have been set, the initial value is the maximum value for the
application sequence that has been set plus 10.
Note, however, that if the maximum value for the application sequence is
greater than 4294967285, the value cannot be omitted.
Range of values:
Set 1 to 4294967295 (in decimal).
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify
<Src
MAC>,
<Src MAC> <Src MAC mask>
-
Specify the source MAC address for
For
<Src MAC
bits that permit an arbitrary value in the MAC address.
<Src MAC>
-
host
The filter condition is a perfect match of
-
any
specification:
The source MAC address is not included as a filter condition.
<Dst MAC>
| any | bpdu | cdp | lacp | lldp
<Ethernet type>
]
| host
<Src MAC>
| any}
any
.
<Src MAC
mask>,
host
specification:
mask>, specify a mask in MAC address format that sets
specification:
permit (mac access-list extended)
| host
<Src-MAC>
| any} {
] [vlan
<VLAN ID>
]
<Src
MAC>, or
any
<Src
MAC>.
<Src
MAC>.
<Dst
.
313
Advertisement
Table of Contents
