Table of Contents
Advertisement
snmp-server host
snmp-server host
Registers the network management device (SNMP manager) to which traps are sent. This
command can configure a maximum of four entries.
Input format
To set or change information:
snmp-server host
| 2c }] [snmp] [rmon] [air-fan] [login] [temperature] [storm-control]
[efmoam] [poe] [dot1x] [web-authentication] [mac-authentication]
[loop-detection] [switchport-backup] [cfm]
To delete information:
no snmp-server host
Input mode
(config)
Parameters
<Manager address>
Sets the IP address of the SNMP manager.
1.
2.
<Community string>
For SNMPv1 and SNMPv2C, this parameter sets the name of the community for the
SNMP manager.
1.
2.
version {1 | 2c}
Sets the version for sending the traps of the manager whose IP address belongs to
the community that has been set. If
2c
is set, SNMPv2C version traps are issued.
1.
2.
630
<Manager address>
<Manager address>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Sets the IPv4 address (dot notation) for
1.0.0.0 to 126.255.255.255, 128.0.0.0 to 223.255.255.255
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify a character string that is no more than 60 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
Default value when this parameter is omitted:
1
Range of values:
1 or 2c
traps
<Community string>
<Manager
address>.
1
is set, the SNMPv1 version traps are issued. If
[version { 1
Advertisement
Table of Contents
