Table of Contents
Advertisement
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3.
This command takes effect only if the
been set.
4.
On the interface on which the
is set,
disabl
command.
Related commands
dot1x vlan dynamic ignore-eapol-start
dot1x vlan dynamic enable
dot1x system-auth-control
dot1x vlan dynamic ignore-eapol-start
e cannot be set for the
dot1x vlan dynamic supplicant-detection
dot1x system-auth-control
dot1x vlan dynamic enable
dot1x vlan dynamic supplicant-detection
command has
command
419
Advertisement
Table of Contents
