Table of Contents
Advertisement
Note, however, that 0x0000 is set for a value equal to or smaller than 0x05ff.
For details about the Ethernet type names that can be set, see Table 20-7
Ethernet type names that can be specified.
vlan
<VLAN ID>
Sets the VLAN ID.
This parameter is effective only when it is applied to an Ethernet interface.
1.
Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2.
Range of values:
See Specifiable values for parameters.
<Priority>
user-priority
Sets the user priority.
1.
Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2.
Range of values:
Set 0 to 7 (in decimal).
Operation parameters
action
To set or change an operation parameter, you must set the
beginning of the operation parameter.
1.
Default value when this parameter is omitted:
None. (This parameter cannot be omitted if an operation is set.)
2.
Range of values:
None
<COS>
cos
Sets an index (CoS) indicating the priority on a Switch.
1.
Default value when this parameter is omitted:
The default CoS values are set. For details about the default Cos values, see
3.7.1 CoS values in the Configuration Guide Vol. 2.
2.
Range of values:
Set 0 to 7 (in decimal).
replace-user-priority
Sets the value for rewriting the user priority.
Replace the user priority of the received packet with <Priority>.
1.
Default value when this parameter is omitted:
None. (The user priority is not replaced.)
2.
Range of values:
Set 0 to 7 (in decimal).
<Priority>
qos (mac qos-flow-list)
action
parameter at the
347
Advertisement
Table of Contents
