Table of Contents
Advertisement
Notes
1.
This command cannot be set for non-gigabit interfaces.
2.
If
media-type
default state:
duplex
,
mdix auto
3.
If
media-type auto
value.
,
duplex
mdix auto
4.
When
media-type auto
transceiver inserted, ports are not switched automatically because 1000BASE-X
link-up does not occur. Therefore, for 1000BASE-SX2, use either of the following
methods:
Use the fixed media setting.
Make sure an optical fiber cable and a UTP (RJ45) cable are not inserted at the
same time.
5.
If a 1000BASE-BX# SFP transceiver is inserted when
10BASE-T, 100BASE-TX, or 1000BASE-T (RJ45) link is enabled, a link-down occurs
temporarily for 10BASE-T, 100BASE-TX, or 1000BASE-T.
#:
1000BASE-BX10-D, 1000BASE-BX10-U, 1000BASE-BX40-D, or
1000BASE-BX40-U
When operation on the RJ45 side has precedence, insert the 1000BASE-BX SFP
transceiver by using either of the following methods:
Insert an SFP transceiver with the fixed media (RJ45) setting.
Insert the SFP transceiver before turning on the Switch.
6.
When inserting a 100BASE-FX SFP transceiver, use the following settings:
media-type sfp
speed 100
duplex full
In addition, if you use 10BASE-T, 100BASE-TX, 1000BASE-T or 1000BASE-X after
using 100BASE-FX, change the following settings in the order given before starting
use:
1)
no speed
2)
no duplex
3)
no media-type
Related commands
duplex
mdix auto
speed
is changed, the settings of the following commands return to the
, and
speed
is set, the following commands cannot be set. Use the default
, and
speed
is set and RJ45 is used with a 1000BASE-SX2 SFP
media-type
media-type auto
is set and a
87
Advertisement
Table of Contents
