ethernet cfm mep
Sets a MEP used in CFM.
Input format
To set information:
ethernet cfm mep level
To delete information:
no ethernet cfm mep level
Input mode
(config-if)
Parameters
level
<Level>
Sets the domain level that has been set by using the
command.
1.
2.
<No.>
ma
Sets the MA ID number that has been set by using the
vlan-group
1.
2.
mep-id
<MEPID>
Sets the MEP ID.
1.
2.
3.
{down | up}
Sets the direction of a domain.
down
up
<Level>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 7
command.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 65535
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 8191
Note on using this parameter:
Set a value unique within the MA.
Set the MEP as Down MEP so that the line side will be maintained.
Sets the MEP as Up MEP so that the relay side (toward the Switch) will be
ma
<No.>
mep-id
<Level>
ma
<No.>
mep-id
ethernet cfm domain
ethernet cfm mep
<MEPID>
[{down | up}]
<MEPID>
ma name
command or the
ma
609