Dot1X Radius-Server Dead-Interval - Alaxala AX1250S Software Manual

dot1x radius-server dead-interval

Configures the timer for monitoring automatic restoration to the primary IEEE 802.1X
authentication RADIUS server from the IEEE 802.1X authentication RADIUS server.
The primary IEEE 802.1X authentication RADIUS server is restored when either of the
following occurs: The current server (the destination for RADIUS authentication requests in
operation) switches to a valid secondary IEEE 802.1X authentication RADIUS server, or
when all servers are disabled, the monitoring timer starts and the period of time set by this
command elapses (when the monitoring timer expires).
Input format
To set or change information:
dot1x radius-server dead-interval
To delete information:
no dot1x radius-server dead-interval
Input mode
(config)
Parameters
<Minutes>
Configures the timer for monitoring automatic restoration to the primary IEEE 802.1X
authentication RADIUS server from the secondary IEEE 802.1X authentication
RADIUS server.
1.
2.
Default behavior
The primary IEEE 802.1X authentication RADIUS server is automatically restored 10
minutes after the current server switches to the secondary IEEE 802.1X authentication
RADIUS server.
Impact on communication
None
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 1440 (minutes)
If 0 is set, RADIUS authentication requests are always initiated from the
primary IEEE 802.1X authentication RADIUS server.
dot1x radius-server dead-interval
<Minutes>
391