Alaxala AX1250S Software Manual page 657

poe
A trap is sent when the power status changes or the total power consumption
of a Switch exceeds the threshold.
dot1x
A trap is sent for specific types of authentication accounting log data during
IEEE 802.1X authentication.
web-authentication
A trap is sent for specific types of authentication accounting log data during
Web authentication.
mac-authentication
A trap is sent for specific types of authentication accounting log data during
MAC-based authentication.
loop-detection
A trap is sent when an L2 loop is detected.
switchport-backup
A trap is sent if a line is switched due to uplink redundancy.
cfm
A trap is sent when a failure is detected by CC.
1. Default value when this parameter is omitted:
No traps corresponding to those parameters are issued.
2. Range of values:
snmp
dot1x
switchport-backup
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. For the list of supported MIBs and supported traps, see the manual MIB Reference.
2. For details about the conditions for issuing private traps for specific types of
authentication accounting log data and each authentication functionality (IEEE
802.1X, Web authentication, and MAC-based authentication), see the description
about the accounting functionality of each type of authentication in the Configuration
Guide Vol. 2.
3. air-fan can be set only for models with a fan and
supports the PoE functionality.
4. 127.*.*.*
, rmon , air-fan , login
, web-authentication
, and cfm
cannot be specified as an IPv4 address.
, temperature , storm-control
, mac-authentication
poe can be set only for models that
snmp-server host
, efmoam , poe ,
, loop-detection ,
633