Table of Contents
Advertisement
authentication arp-relay
authentication arp-relay
When the Layer 2 authentication functionality is used, set this command to output ARP
packets destined for another device sent from an unauthenticated terminal to a
non-authenticating port.
This command can be used in the following authentication modes:
IEEE 802.1X: Port-based authentication (static), port-based authentication (dynamic)
Web authentication: Fixed VLAN mode, dynamic VLAN mode
MAC-based authentication: Fixed VLAN mode, dynamic VLAN mode
Input format
To set information:
authentication arp-relay
To delete information:
no authentication arp-relay
Input mode
(config-if)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
When setting this command, you must set one of the following commands for the
applicable port in advance:
2.
When you use authentication IPv4 access list for IEEE 802.1X port-based
authentication (static), note the following:
3.
Interfaces that can be set for the
360
dot1x port-control
web-authentication port
mac-authentication port
If
extended-authentication
command was set, this command cannot be set. (This command can be set if
the
system function
was not set when the
command was not set.)
authentication ip access-group
system function
command vary
Advertisement
Table of Contents
