Table of Contents
Advertisement
snmp-server traps
mac-authentication-trap {failure | all}
Sets the trap type for MAC-based authentication.
failure
all
1.
2.
Default behavior
The initial values for all parameters of this command are used.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
For the list of supported MIBs and supported traps, see the manual MIB Reference.
2.
You cannot omit all of the parameters in this command. You must set at least one.
Related commands
None
638
failure
or
all
Only traps for an authentication failure are issued.
Traps for both successful and failed authentication attempts are issued.
Default value when this parameter is omitted:
failure
Range of values:
failure
or
all
Advertisement
Table of Contents
