Table of Contents
Advertisement
dot1x timeout server-timeout
Sets the time (in seconds) to wait for a response includes the time required for
retransmitting a response to an authentication server.
Input format
To set or change information:
dot1x timeout server-timeout
To delete information:
no dot1x timeout server-timeout
Input mode
(config-if)
Parameters
<Seconds>
Sets the time (in seconds) to wait for a response.
1.
2.
Default behavior
30 seconds is used as the time to wait for a response.
Impact on communication
None
When the change is applied
When the operating timer times out (the value of the timer becomes 0).
When authentication processing starts
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3.
The
port-control
Related commands
dot1x system-auth-control
dot1x port-control
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535 (seconds)
dot1x timeout tx-period
command has been set.
<Seconds>
dot1x system-auth-control
command takes effect only if the
dot1x timeout server-timeout
dot1x
405
Advertisement
Table of Contents
