Table of Contents
Advertisement
ethernet cfm mip
Sets a MIP used in CFM.
Input format
To set information:
ethernet cfm mip level
To delete information:
no ethernet cfm mip level
Input mode
(config-if)
Parameters
level
<Level>
Sets the domain level that has been set by using the
command.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If the
to or lower than the
2.
This command cannot be set for an Ethernet interface that is set for a channel group.
Also, an Ethernet interface set by using this command cannot be set for a channel
group. Set this command for the port channel interface to which the applicable
Ethernet interface belongs.
Related commands
ethernet cfm domain
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 7
ethernet cfm mep
command is set on the same interface, a domain level equal
ethernet cfm mep
<Level>
<Level>
command cannot be set.
ethernet cfm mip
ethernet cfm domain
611
Advertisement
Table of Contents
